Removal and Cleaning of your Powerhead:

1) Carefully remove the powerhead.

2) Remove both air lines and the powerhead cover by inserting a flat-head screwdriver into slot (C) and prying very gently. (If you pry too hard you may break off the tabs which hold down the Rejuvenation plate, causing bubbles to escape from the powerhead.)

3) Remove the round Rejuvenation plate by lining up the flat portion to the locking guide. Be sure not to lose the small "O" ring that fits around this plate and make sure that it is still intact.

4) Wash all parts under warm tap water. Do not use any detergents. Make sure that both air lines and gray elbows (A) are clear of any foreign matter, calcium buildup or salt creep before reassembling.

5) Reassemble the powerhead and place it back into position.